Solutions for bar manufacturers

3

Technology Pioneers

ISEND® Non-Destructive Testing solutions for bar cover every regular production process, whether the metal is ferromagnetic or not. 

The following section provides information on the different solutions that ISEND® can offer to bar transformers, either by calibration or by any other process.

ROTOdiscover

Detection of long surface defects for cold inspection

Maximum speed

Minimum diameter

With ROTOdiscover solution most of longitudinal defects can be detected. To its great strength and reliability must be added versatility, because there are different configurations for a wide range of needs. The ROTOdiscover solutions of ISEND® allow inspection from 2 mm diameters with high reliability, they can be configured properly for high and low frequency. Moreover, it enables:

– Several coil configurations (2+1, 4+1)
– Lift off control
– High precision guiding
– Reduced maintenance
– Advanced testing of cold formed long products. (Longitudinal defects).
– Longitudinal defects less than 50 microns deep

ENdiscover

Detection of point surface defects for cold inspection

Strong and repetitive

Fast change of diameter system

With or without magnetizing

ENdiscover® encircling solutions has been design to detect single, point and transversal defects with the highest sensibility both in magnetic and non-ferromagnetic materials. ENdiscover® solutions can also be used for material characterization using variations in its physics properties such as hardness or conductivity.

– Last generation fully digital electronics 

– Robust and repetitive

MATdiscover

Classification of metallic materials

Probes adaptable to the geometry to be inspected

To classify parts depending on their physical properties

On-line or off-line 

MATdiscover® is a powerful tool to sort materials online based on its physical properties such as hardness or conductivity.

MATdiscover® solution is for manufacturers of automobile parts or nuts and bolts interested in production quality control. It allows to classify parts depending on their physical properties and hardness.